Your location-Home - News - Company News

Company News

How to protect the digital equipment when traveling

We will carry a variety of electronic devices, such as mobile phones, cameras or laptops, while traveling. However, many people do not know how to protect their own equipment. According to a recent survey, 8% of people in the public toilets to the phone charge, but do not know this may bring health, theft and equipment, water problems. Considering that 70% of travelers will carry laptops, you should probably know that putting your notebook in a backpack is easy to cause it to overheat and damage the battery. If you often need to travel, sum up the following four of the correct way to protect the battery of electronic equipment should be able to benefit you a lot.

How to protect the digital equipment when traveling battery - Ami fruit electronics - love her husband enelong rechargeable battery & nbsp;

Do not put electronic equipment on a backpack

While traveling, we usually put laptops or other portable devices in the backpack. But the electronic equipment into a closed, non-ventilated space is very easy to cause the body overheating and damage the battery. Even if the device is turned off, the heat emitted by the battery can be trapped in the backpack can not be discharged, resulting in thermal runaway and lead to dangerous situations. Prior to this, there have been manufacturers because of their own products, lithium batteries may be overheating and the risk of fire or explosion and recalled.


If you intend to put the electronic equipment into a closed backpack, you must make sure that its battery is cool, even in the off state. In addition, you can also check the way through the backpack to avoid the battery due to heat or sunlight and overheating. It is a hassle to avoid charging in an insecure environment for charging electronic equipment. In the survey, many participants have said they have in the gas stations, shopping malls, restaurants and even public toilets which charge the equipment over electricity. As mentioned at the beginning of the article, charging these electronic devices in these unconventional environments can lead to a variety of unexpected problems.


In the trip, you should prepare extra batteries - and properly store them - to cope with the situation where the equipment is no electricity. If your device can not replace the battery, mobile power is also a convenient choice, especially in the case of no charge.
Do not listen to the so-called battery maintenance method Do not charge all night, to ensure full use and then use, and occasionally the battery power completely light once ... ... we will always see these life in the so-called the best way to charge, but you questioned Their accuracy


The truth is that most of these suggestions are wrong, at least for today's lithium-ion batteries. For example, the complete depletion of the battery will actually shorten the battery life. But according to the survey, about 33% of users will wait until the remaining power below 10% to start charging. When using electronic equipment, you should keep the remaining charge between 40-80% as much as possible, and avoid frequent discharge。


In addition, keeping the charging state of the device (charging all night) is not necessarily a bad thing, because most devices will automatically stop charging after they are fully charged. Finally, you should ensure that the device is in a cool environment when charging, if the battery appears too high fever, should immediately stop charging.


Do not have to shut down the charge should be shut down on the issue of charging, there are two main points of view: one group that shut down charging equipment parts to avoid loss, charging speed will accelerate; and another school that the switch is more likely to wear parts, and Boot state charge faster。


In fact, the switch machine for modern electronic equipment parts will not have much impact. However, for devices that use lithium batteries, charging in the off-state allows the device to reach a low saturation current when fully charged, thus avoiding sustained pressure on the battery. However, in the boot state, most of the equipment is fully charged after the current bypass the battery directly to the equipment for power. All in all, when to shut down, whether the frequent shutdown is not important for electronic equipment.


Times the force, 13 years focus on rechargeable battery research and development